Home > SPORTING GOODS > MARINE, HUNTING & CAMPING > MARINE/BOATS & ACCESSORIES
Choose a sub category:
MARINE ACCESSORIES DOCK KITS/DOCK HARDWARE
Sort By:
1 2
BACK PLATE COMM GRAD .25X1.5X5 PIPE SAFETY CAPS 4PIEC 1.5X3X3 GUSSET COMMER GRADE .25X1.25X8
Heavy duty hot dipped galvanized washer. Fits 1 5/8" outside diameter pipe. Packaged in set of 4. Reinforces inside corners.
DOCK CONNECTOR CLIPS STAN GALV CLEAT DOCK RESIN 1.5 X 1 X8 IN Playstar PS 1015 Joist Corner Bracket
Use to connect roll in and stationary dock sections. 8" cleat with large tie off area. Mounts with two screws (Not Included). Reinforces and supports frame.
FLOATNG DCK PIPE SLEEV STANDRD Playstar PS 1412 Standard Duty Inside Corner Bracket CLEAT NYLON BLK 6X1X1-1/4 INCH
Fits 1 5/8" outside diameter pipe. Powder coated steel reinforces dock frame corners. Screw mounting centers.
American Hardware M-008C T-Handle Drain Plug American Hardware M-029C Bailer Plug American Hardware M-003C Drain Plug
Brass. For 1" diameter drains. Cam-action neoprene plugs. Snap shut to form a leakproof stopper for Livewells or Baitwells. For 1" diameter drains.
CONNECTOR BARB FUEL FMLE 3/8IN United States Hardware M-047C 2-Way Bilge Pump Switch American Hardware M-318C Bailer Plug
For OMC, Johnson, and Evinrude. Features ultrasonicly welded acetal. 3/8" Barb. Panel-mounted rocker switch for use with pump that draws 10 amps or less. 1/4" spade terminals. 6 Volt through 32 Volt D.C. only. NOTE: Not externally ignition protected. Cam-action neoprene plugs. Snap shut to form a leakproof stopper for Livewells or Baitwells.
MOORING RING 3 IN HVY DTY GALV Playstar PS 1145 Dock Float Hardware Playstar PS 1135 Dock Frame Hardware
3" heavy duty ring. Hot dipped galvanized for long life. Hot-dipped galvanized for long life. Includes enough screws and washers to attach 3 PlayStar marine dock floats to frames. Contains twelve 3/8" x 2" lag screws and twelve 3/8" flat washers. Hot-dipped galvanized for long life. Includes fasteners for use with PlayStar's Framing Kits, Hinge Kits, and Pipe Sleeves. Contains twelve 3/8"-16 x 3" carriage bolts, twelve 3/8" flat washers, twelve 3/8" lock washers, and twelve 3/8" nuts.
MOTOR FLUSHER MARINE FR ENGINE American Hardware M-037C Pole Storage Clip DOCK CONNCTR CLIP 5 X 7.25 X 5
Fits most engines with side water inlets. Flushes away sand, silt, salt, and alkali. Prevents clogging and corrosion, extending the engine life. Installs in seconds without tools. All round light. Rubber storage clips hold pole when not in use. Nickel plated brass finish washer suitable for up to #8 fastener. Securely attaches stationary and roll in docks. Hot dipped galvanized for long life.
RING LIFTNG SM MARINE 1-1/2 IN Playstar PS 1011 Inside Corner Bracket FUEL LINE FITTNG MARINE 1/4 IN
Pre-drilled to accommodate four #6 screws. Durable chrome plated brass ring is small enough to fit on most hatches, cabinets and drawers. Hot dipped galvanized for long life.  Prevents twisting and bending. Fuel connector, male for OMC engines. Brass construction and 1/4" NPT thread.
FOOT PLATE COMM GRADE 2.25X6X6 BUMPER TORPEDO FOAT 5.7X5.7X17 American Hardware M-278C Corrosion Resistant Drain Plug
Fits 1 5/8" and 1 7/8" diameter pipe. Inflatable. For use on boats. Protects all sizes of boats. For 1" diameter drains.
AIR HORNS SIGNAL MARINE 1.4 OZ FLOATING DOCK AUGER STANDARD Playstar PS 1013 Outside Corner Bracket 5 in L x 8 in W x 8 in H
Recommended for boats up to 12 meters/39.4 feet. Non-flammable, no CFC'S. Good for over 80 blasts. Ideal for marine safety sporting events. Easily, and securely, anchors dock pipe to bottom. One piece, heavy-duty cast iron construction securely fastens to pipe with single stainless steel nut and bolt. Hot dipped galvanized for long life. Use with No.PS1080 Commercial Grade pipe sleeve. For use with 1-5/8" O.D. and 1-7/8" O.D. dock pipe. Hot dipped galvanized for long life.  Securely ties frame together.
   
 
1 2